View previous topic :: View next topic |
Author |
Message |
Pillingb
Joined: 28 Jun 2017 Posts: 11 Location: Cumbria
|
Posted: Sun Jun 13, 2021 8:48 pm Post subject: YB9 velocity stack |
|
|
Just started recommissioning an old YB9. I have discovered I only have three of the four velocity stacks and the FZR velocity stacks available on ebay are much taller.
Could I use the tall FZR stacks with out further carburetor adjustments? Or should I take them all off!
Needless to say I cannot see any of the stubby YB9 velocity stacks.
Any thoughts? Thanks in advance. |
|
Back to top |
|
![](templates/BimotaForum/images/spacer.gif) |
phil-short
![](images/avatars/56207579550185b95ed7f6.gif)
Joined: 30 Jul 2012 Posts: 197 Location: Dublin,Ireland
|
Posted: Wed Jun 16, 2021 7:54 pm Post subject: |
|
|
Don't know whether the price would be over the top but how about getting one 3d printed to match? |
|
Back to top |
|
![](templates/BimotaForum/images/spacer.gif) |
Pillingb
Joined: 28 Jun 2017 Posts: 11 Location: Cumbria
|
Posted: Thu Jun 17, 2021 3:34 pm Post subject: |
|
|
That’s an interesting idea I hadn’t considered it. I think what I’ll do is change them all to the tall fzr stacks and see how it goes. I suspect it will make little difference but for a little more top end perhaps.
But, if this doesn’t produce a smooth running engine my brother is a cad engineer and I think he recently bought a 3D printer!
Good thinking Phil! Thanks for the prompt. |
|
Back to top |
|
![](templates/BimotaForum/images/spacer.gif) |
|