Bimota Forum

Hi, please note that these parts are for one leg. They are off a brand new bike disassembled for parts, think pictures would only show the same. Did you buy from me when I (OCR1000) was on ebay? Jon

Hi, please note that these parts are for one leg. They are off a brand new bike disassembled for parts, think pictures would only show the same. Did you buy from me when I (OCR1000) was on ebay? Jon

Former Norwegian importer is having a final clean up. Parts came of a new bike disassembled for parts. Following parts are included: damper rod unit, spring, upper adjuster, lower adjuster and both bu ...

Former Norwegian importer is having a final clean up. Part came of a new bike disassembled for parts back in 2001. Asking Euro 250 shipping included. Paypal prefered.

Former Norwegian importer is having a final clean up. New parts. Asking Euro 150 shipping included. Paypal prefered.

Former Norwegian importer is having a final clean up. Asking Euro 100 shipping included. Paypal prefered.

Former Norwegian importer is having a final clean up. Asking Euro 100 shipping included. Paypal prefered.

I have checked with my computer and it looks like I have one last kit for the DB2 (5x14mm pins and 5xrubbers). Contact me at jonoft@frisurf.no if you are interested.

Now, cush drive rubbers are not ...

If the cush drive rubbers are shagged you should check the 5 "drive pins". They may have developed cracks so remove them and inpect both them and the hub carefully. Bimota first fitted " ...

Probably sorted by now, but here is my input. On the Mantra there is a vacuum fuel pump fixed to the bottom of the tank tank. The pump has 3 stubs; fuel in, fuel out and manifold vaccum. The only prob ...

It is a bit tricky, yes. But there is a 2 mm gap between the stepper motor and the needle. You need a pair of jewellers nose-pliers. Use it to hold the tiny shaft or axle of the stepper motor and try ...

Keith, yes I am ocr1000 on ebay. (It is after my Van Veen OCR 1000). If you don't see it as me spamming big-time I could list the bits on this site and give you guys first refusal so to speak. But rea ...

They are glued. I've been out of town and have just read your mail. I have now found an used instrument, but I don't know yet about the condition. I'll let you know after the weekend.

Regards
...

I guess this is spamming, but you might be interested in knowing about it. I am selling the last Bimota bits in stock. There really is not much left and some of it is not in much demand either. Anyone ...

Bimota used a Stanley knife to open these clock. I used a Stanley knife and a heat gun to very carefully heat the plastic before cutting the case open. It is difficult to get a clean cut, but it can b ...