Bimota Forum

The two across the top.

Has anyone had their cylinders replated?
If so, did you have to replace the power valve actuator shaft bushings, and if so where did you source them from?

I'm asking because when millennium replat ...

Anyone know the front fork spring rate?

I finally got my hands on a Evoluzione Fuel Trimmer so here are the calibrations for the different maps. These fuel trimmers are NOT infinitely
adjustable as some have been told or say! Other than ...

Outstanding Build!! What A Work of art!!
Any possibility that your carbon guy would make another set of snorkels and airbox? I'm going to try and finish mine up this summer and was going to look at ...

Correct, you should see a ground signal on the black-cyan wire when you supply power to the ecu. I'm in the USA also. Yes, Bob is a great guy, I know him personally. He can fix you up!

Check the pins #17&34 on ecu connector for ground and pin #35 for +12v (ignition turned on).
If these pins check out correctly then you have a bad ecu.

I would check to make sure the ecu is sending a ground signal to the fuel pump relay. That wire is black/cyan in color. Hook up a ohm meter between ground and the black/cyan wire.Turn on the ignitio ...

Why do you think you need to swap them out?

Yamaha Part# 5HO-12462-00

Good to know the fuel pump and injectors come to life.
That means the ecu is booting up correctly.

Check the camshaft position sensor according to the TL manual.
You will find it on top of the re ...

Welcome and sorry to hear about your admission! Shocked

The burning of the stator wires is common, it is caused by the voltage regulator calling for a higher charging voltage than it really need ...

PM sent.

It makes a big difference. How you install the bearings determines if the wheel is centered correctly. And lets not forget about the rotors and sprocket.

I'm replacing the bearings in a set of 5 spoke Marchesini magnesium rims, and the importer/distributor for the US market could not tell me which bearing is installed first. The person told me,"I ...